EV Charger Installation for Homes and Businesses
Level 2 chargers, Tesla Wall Connectors and NEMA 14-50 outlets installed on a dedicated circuit, with a load check first so you know exactly what your panel can carry.
Serving Lansdale, the North Penn area, Montgomery County, Bucks County and Philadelphia. 83 Google reviews, rated 5.0.
- ●HIC License PA197924
- ●15+ Years Experience
- ●OSHA 30 Certified Technicians
- ●Fully Insured
- ●Same Day Service Available
- ●Upfront Flat Pricing
EV charger installation means running a dedicated 240 volt circuit from your panel to a Level 2 charger or outlet, sized to the charger and your home’s available capacity. TotalPower Electrical Services installs Tesla, ChargePoint and other Level 2 chargers for homes and businesses in Lansdale, Montgomery County and Philadelphia, and runs a load calculation first so you only upgrade your panel if you need to.
A Level 2 charger typically adds 20 to 30 miles of range per hour of charging, compared with a few miles per hour from a standard 120 volt outlet. Getting there safely depends on three things: whether your service has room for the load, how far the charger is from the panel, and whether it is hardwired or plugged into a 240 volt outlet.
We look at all three on the first visit. In older Lansdale twins and Philadelphia rowhomes, the service size and the parking situation usually decide the plan. In newer township homes with 200 amp service, the job is often a straightforward circuit and mount.
Is Your Home Ready for a Level 2 Charger?
These are the questions we answer before quoting:
- What size is your service: 100, 150 or 200 amps?
- Are there open breaker spaces in the panel?
- How far is the parking spot from the panel?
- Garage, driveway or exterior wall mount?
- Hardwired charger or NEMA 14-50 plug-in?
- Do you want to charge more than one vehicle?
- Is the property inside Lansdale Borough, another township or Philadelphia?
Send a photo of your panel label and where you park, and we can usually tell you which option fits before we visit.
EV Charging Services
Installed by licensed and insured electricians, permitted and inspected where required.
Level 2 Home Charger Installation
Hardwired Level 2 chargers on a dedicated 40 to 60 amp circuit, mounted in the garage, on an exterior wall or on a pedestal.
Tesla Wall Connector Installation
Tesla Wall Connectors installed on the correct breaker size, set up for your circuit and tested at full charging speed.
NEMA 14-50 Outlet Installation
240 volt NEMA 14-50 outlets for plug-in chargers and mobile connectors, on a properly sized dedicated circuit.
Load Calculations
A full load calculation on your existing service, so you know whether the charger fits as is, needs load management or needs a panel upgrade.
Panel Upgrades for EV Charging
When the service is too small, we handle the panel or service upgrade and the charger as one job.
Commercial EV Charging
Charging stations for businesses, offices and multi-unit properties, including load planning, dedicated circuits and conduit runs.
Two Charger Setups
Wiring for two vehicles, either with two circuits or with load sharing chargers that split one circuit.
EV Charger Troubleshooting
Fixing chargers that trip, charge slowly or stopped working after an earlier install.
Brand Support
Tesla, ChargePoint and other major Level 2 chargers, including units you have already bought.
Recent EV Charger Installations
Real jobs completed by TotalPower crews. No stock photos.
See more finished jobs on our recent projects page.
What Customers Say
“I couldn’t be more impressed with Malvin and team at TotalPower Electrical. They took the time to thoroughly assess our family’s electrical needs and provided thoughtful recommendations tailored to our home.”Nicole R. Google review
“TotalPower provides great customer service and is extremely knowledgeable.”Bryan R. Google review
Why EV Owners Choose TotalPower
Load check first, upsell never. We tell you honestly whether your current panel can carry the charger. If it can, you do not pay for an upgrade you do not need.
The breaker, wire and charger setting are matched. A 48 amp charger needs a 60 amp circuit, and a NEMA 14-50 outlet is limited to 40 amps of continuous charging. Getting that wrong causes nuisance trips and overheated outlets.
We file the permit where your municipality requires one and leave you with the inspection record, which some utilities and rebate programs ask for.
HIC License PA197924, full insurance and OSHA 30 certified technicians on every job.
How EV Charger Installation Works
-
Send us the basics
Your car, the charger you want or already bought, a photo of the panel and where you park.
-
Load check and quote
We confirm the circuit size, wire route and mounting, and give you a written flat price.
-
Permit if required
We file with Lansdale Borough, your township or Philadelphia as needed.
-
Installation day
Most home chargers are installed and tested in a few hours.
-
Test and handover
We confirm the charger is drawing the right current and show you the breaker and settings.
How Much Does EV Charger Installation Cost?
The biggest factors are the distance from the panel to the parking spot, whether the panel has capacity and open spaces, and whether the wire runs through finished walls. These ranges reflect recent installs; your written quote may differ.
| Job | Typical range | What moves the price |
|---|---|---|
| Level 2 charger install, panel has capacity | $800 to $2,500 | Run length, finished walls, mounting location |
| NEMA 14-50 outlet | Quoted on site | Run length, wall finish, panel space |
| Panel upgrade plus charger | Quoted on site | Service size, meter and utility work |
| Commercial charging station | Quoted on site | Number of chargers, trenching, load planning |
Charger hardware is usually purchased separately. Check current federal, state and utility incentives before you buy, as programs change.
Get a Free Estimate
Tell us your car, the charger you plan to use and send a photo of your panel. We will confirm whether it fits your current service.
- Written flat price before any work starts
- Permits filed with the correct borough, township or city office
- Same day slots on weekdays for repair calls
Prefer to send details?
Tell us your town, the job and a good time to call. We reply with next steps and an arrival window.
Send your job details or email Totalpowerpa@gmail.com.
EV Charger Installation Near You
We install home and business EV chargers in Lansdale, North Wales, Blue Bell, Horsham and across Montgomery County, Bucks County and Philadelphia.
- Lansdale
- North Wales
- Blue Bell
- Ambler
- Horsham
- Fort Washington
- Warminster
- Abington
- Jenkintown
- Bensalem
- Newtown
- Havertown
- Philadelphia
- All areas we serve
Related services
EV Charger Installation Questions
How much does it cost to install a Level 2 EV charger?
Most home Level 2 installs we complete fall between $800 and $2,500 when the panel already has capacity. Run length, finished walls and mounting location move the price. A panel upgrade, if needed, is quoted separately.
Do I need a panel upgrade for an EV charger?
Not always. We run a load calculation first. Many 200 amp homes can add a Level 2 charger as is, while 60 and 100 amp services often need an upgrade or a load managed charger.
What size circuit does a Tesla Wall Connector need?
For full 48 amp charging, a Tesla Wall Connector needs a 60 amp circuit. It can also be set for a smaller circuit at a lower charging speed if your panel is limited.
Should I hardwire my charger or use a NEMA 14-50 outlet?
Hardwiring allows higher charging speeds and avoids wear on an outlet. A NEMA 14-50 outlet gives flexibility to swap chargers but is limited to 40 amps of continuous charging and should use a quality, properly rated receptacle.
How long does EV charger installation take?
Most home installs take a few hours. Jobs that need a panel upgrade or a long run through finished space can take a full day.
Do I need a permit to install an EV charger?
Most municipalities require a permit for a new 240 volt circuit. We file with Lansdale Borough, your township or Philadelphia when required and leave you with the inspection record.
Can you install a charger outside?
Yes. We install outdoor rated chargers on exterior walls and pedestals with weather rated fittings and the right protection for the location.
Can I charge two EVs at home?
Yes. Options include two dedicated circuits or load sharing chargers that split one circuit between vehicles. The load calculation shows which works for your service.
Which charger brands do you install?
We install Tesla, ChargePoint and other major Level 2 brands. If you have not bought one yet, we can recommend options that fit your panel.
Do you install EV chargers for businesses?
Yes. We install charging stations for offices, retail sites and multi-unit properties, including load planning and conduit runs.
How do I get an EV charger installation quote?
Call or text 267-312-8232 with a photo of your panel and parking spot, or send the form on this page. Estimates are free.
Ready to Charge at Home?
Send us a photo of your panel and where you park, and we will tell you exactly what your EV charger install involves.
Call 267-312-8232, email Totalpowerpa@gmail.com, or send us your job details. You can also find us on Google Maps.